C-AS-MMP ANGLED SERIES CONSOLES
INSTALLATION INSTRUCTIONS
FOR MODELS C-AS-1025, 1325, 1525 & 1725
TOOLS REQUIRED:
Standard and Metric Socket Set with 6” Extension
Standard and Metric Wrench Set
Torx driver #T15 and #T20
HARDWARE:
QTY: DESCRIPTION:
PART #:
12
4
4
#8 X 3/8 Black Torx Screw
¼-20 X ½” Pem Stud
¼” Lock Washer
CM86508
GSM32220
GSM31026
GSM30005
4
¼-20 Hex Nut
PARTS SUPPLIED
1
1
1
CM93569 – Monitor Platform Frame
CM93628 – Support Plate
Pair of Wire Panels
C-AS-MMP
C-AS-MMP-CV
C-AS-MMP-IMP
Monitor Mounting Platform
& Wire Panels Crown Vic
Monitor Mounting Platform
& Wire Panels Impala
Monitor Mounting Platform
INSTALLATION: (Refer to pictures on page 2)
1. Turn console over and remove (2) #8 X 3/8” Black torx screws on bottom of console.
2. Place support plate on bottom of console as shown and replace (2) #8 X 3/8” Black torx screws.
3. Turn console back over and place (4) ¼-20 X ½” pem studs on bottom of support plate and insert
(4) ¼” lock washers and (4) ¼” Hex nuts over studs on inside of console housing, then tighten.
4. Place monitor platform on front side of console and secure with (6) #8 X 3/8” Black torx screws.
5. Place wire panels on front sides of console and secure with (6) #8 X 3/8” Black torx screws.
6. Console is ready for mounting in car.
|
Brother MFC 8680DN User Manual
Bunn TDS5 User Manual
Carrier 40RMS008 034 User Manual
CK Electric Part C3000 User Manual
Danby DAC7006DE User Manual
Exide S47 0079 User Manual
Garmin ARTISAN 725 User Manual
Graco MetroLite 1761213 User Manual
Heat Controller Inc Air Conditioner REG 183A User Manual
HP Hewlett Packard WORKCENTRE 228 User Manual